EJOT

EJOT was founded in 1922 as Adolf Böhl GmbH & Co. KG, a screw and nail manufacturer in Bad Berleburg, Germany, where the group is still headquartered. EJOT serves the construction, automotive and electronics industries, and its building fasteners division supplies self-drilling and self-tapping screws, insulation fixings and anchors for building envelopes. A representative office for EJOT building fasteners is listed in Ho Chi Minh City.

In a pre-engineered building, cladding fasteners determine whether the roof and walls stay attached and watertight. Self-drilling screws fix trapezoidal sheeting and trims to cold-formed purlins and girts; the drill point must suit the thickness of the substructure, and the thread form must match steel or timber substrates. Sealing washers with vulcanised EPDM provide the seal on through-fastened roofs. Fastener material is selected for the corrosivity of the environment and for compatibility with aluminium-zinc coated and pre-painted sheet; austenitic stainless steel fasteners are used in severe environments. Fastener spacing in edge and corner zones is governed by wind uplift and by the tested pull-out and pull-over resistances published by the manufacturer.

PEB 및 철골 구조에 사용되는 제품

• Self-drilling screws – fixing sheeting to cold-formed purlins and girts
• Self-tapping and stitching screws – side laps, trims and flashings
• Insulation fixings – fixing insulation boards and membranes
• Stainless steel building fasteners – severe environments

베트남 내

EJOT building fasteners are supplied in Vietnam; a building fasteners representative office is listed in Ho Chi Minh City.

브랜드명과 상표는 각 소유자에게 귀속됩니다. 브랜드를 게재한 것이 World Steel과의 제휴나 World Steel의 보증을 의미하지 않으며, 자재는 프로젝트별 시방서와 승인된 제출 자료에 따라 선정됩니다.