ENEnglish
VITiếng Việt
ZH中文
KO한국어
JA日本語
FRFrançais
ITItaliano
PTPortuguês
ESEspañol
HEעברית
ARالعربية
美国
- M16 – M64, class 4.6 / 5.6 / 8.8
- L, J, headed, straight with plate
- Hammer-head for anchor channels
- Rolled or cut threads, any projection
- Hot-dip galvanized or plain
- Supplied with nuts, washers and templates
Range
| Size | Pitch | As (mm²) | 4.6 ultimate | 8.8 ultimate | Typical use |
|---|---|---|---|---|---|
| M16 | 2.0 | 157 | 63 kN | 126 kN | Canopies, light frames |
| M20 | 2.5 | 245 | 98 kN | 203 kN | Portal frame pinned bases |
| M24 | 3.0 | 353 | 141 kN | 293 kN | Portal frames, mezzanines |
| M30 | 3.5 | 561 | 224 kN | 466 kN | Fixed bases, crane columns |
| M36 | 4.0 | 817 | 327 kN | 678 kN | Heavy frames, towers |
| M42 – M64 | 4.5 – 6.0 | 1120 – 2680 | 448 – 1072 kN | 930 – 2224 kN | Equipment, silos, tall columns |
Ultimate tensile loads As × fu are shown for selection only – anchor design checks steel, pull-out and concrete failure.
Types
L and J bolts rely on the bend for anchorage and suit pinned bases; headed bolts – with a hex nut and plate washer at the bottom – carry higher tension through bearing on the concrete. Straight rods with an embedded plate are used for tall piers; hammer-head bolts fit cast-in anchor channels.
Fabricated in our plant
Anchor bolts are cut, threaded, bent and galvanized with the column steel, so the bolt pattern, projection and base plate holes come from the same model. Threads are protected with tape or caps for shipping.
各市场标准与要求
World Steel 设计、加工本产品及编制文件所依据的规范——以及各市场的主要几何与荷载要求。
澳大利亚 / 新西兰
- AS 1111.1Commercial bolts 4.6
- AS 4100Steel structures – anchor bolts
- AS 5216Fastenings in concrete
欧洲
- EN ISO 898-1Property classes
- EN 1992-4Fastenings in concrete
- EN 1993-1-8Anchor bolts in base joints
摘要仅供参考——以项目技术规格书、所采用的规范版本及主管机构要求为准。
表面处理
| 表面处理 | 标准 / 备注 |
|---|---|
| Hot-dip galvanized | ISO 10684 / AS 1214 |
| Plain / black | Oiled, for painted or indoor connections |
